Stmpe1600 example with nucleo board9/5/2023 ![]() ![]() SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT LOSS OF USE, DATA, OR PROFITS OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND Open Hardware tab and click on Build, Deploy & Start to automatically download the generated bin file, stmnucleogettingstarted.bin, on to the connected Nucleo board. ![]() The user LED might be driven by a different Pin on different Nucleo boards. (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES The user LED is driven by GPIO Pin 13 on the Nucleo F401RE board. BE LIABLE FOR ANYĭIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES IN NO EVENT SHALL STMICROELECTRONICS INTERNATIONAL N.V. NON-INFRINGEMENT OF INTELLECTUAL PROPERTY RIGHTS ARE DISCLAIMED. WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" ANDĪNY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED Names of its contributors may be used to endorse or promote productsĭerived from this software without specific prior written permission. The 100nF capacitor across the button should help reduce noise, one side of the button connects to ground through a jumper wire, and I put a 470 resistor between the other side of the button and pin B1. To do that, I try to control the both STMPE1600 circuits to pull-up or down the XSHUT pins for each sensors, one by one. The green ‘LD3’ LED is attached to pin B3 on the board. Good Evening I’m currently working with the X-Nucleo-53L0A1 in order to control 3 VL53L0X sensors (1 on the board and 2 satelllites) using an Arduino Uno. * Neither the name of STMicroelectronics nor the ‘Nucleo’ STM32F031K6 board with a button. Notice, this list of conditions and the following disclaimer in theĭocumentation and/or other materials provided with the distribution. * Redistributions in binary form must reproduce the above copyright Notice, this list of conditions and the following disclaimer. This document provides guidelines to beginners on how to build and run a sample application and allows them to build and debug their application. * Redistributions of source code must retain the above copyright The STM32 Nucleo board is a low-cost and easy-to-use development platform used to quickly evaluate and start a development with an STM32 in 32-pin package, 64-pin package and 144-pin package. Modification, are permitted provided that the following conditions are met: Provided with the STM32 Nucleo boards, the STM32Cube software packages come with several examples and seamlessly work with a wide range of development environments including IAR EWARM, Keil MDK-ARM, Mbed and GCC/LLVM-based IDEs. Redistribution and use in source and binary forms, with or without (annotated) Committer: johnAlexander Date: Mon Nov 28 11:25:33 2016 +0000 Revision: 0:c523920bcc09 Singleshot, polled ranging example using central VL53L0X sensor. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |